28
6.2 Start-Up procedure
The CSL Elite Wheel Base has an improved and faster start-up procedure:
ATTENTION:
When initialisation and auto calibration of the CSL Elite
Wheel Base is in progress never touch the attached steering wheel in or-
der to avoid injuries or incorrect calibration!
•
Step1:
Press the ON/OFF button “
” at the front plate of
the CSL Elite Wheel Base, marked in the picture on the
right hand side:
•
Step2:
The fans start working, the LED above the ON/OFF
“ ” Button is lit red.
•
Step3:
The CSL Elite Wheel Base starts turning to the right side (clockwise)
until mechanical limit is reached. Then it runs back to the the left side
(counter clockwise) and stops…
at the center position (0°) if wheel center was manually
calibrated before.
Note:
If SPR is set to low values or ‘000’ the
CSL Elite Wheel Base will stop in a different position after
calibration run.
at about -60° on the left hand side if wheel center was not yet
calibrated (e.g. after firmware update; see description above in
this chapter)
•
Step4:
The currently installed firmware version is shown
on the LED display of the Fanatec Steering Wheel for a
moment as shown on the picture on the right hand side:
•
Step5:
If the wheel center was not yet calibrated ‘CAL’
is blinking on the LED display of the Steering Wheel as
shown on the picture on the right hand side:
Do manual wheel center calibration as described
in chapter ‘Hotkeys’ of this manual.
The CSL Elite Wheel Base is ready to use
after manual wheel center calibration.
•
Step6:
CSL Elite Wheel Base is ready to use. If the wheel center was
already calibrated before step 5 can be skipped and the CSL Elite Wheel
Base is ready to use immediately. If you use a H-pattern shifter the Wheel
Base firmware will request to calibrate the gears automatically now. Refer
to chapter ‘Shifter calibration mode later in this user manual’.
