21
Indicator bar shows the current Steering
Wheel position, the upper box shows the posi-
tion in digits, the lower box shows the position
as an angle (positive and negative angle re-
lated to the calibrated wheel center position).
The button ‘display test’ activates a signal flow on the LED display of the at
-
tached Fanatec Steering Wheel and activates all LED display segments so you
can check if all LED display segments work properly.
The button ‘FFB test’ starts a force feedback test and activates the motor of the
CSL Elite Wheel Base to check proper functionality.
The button ‘Wheel Base RevLEDs test’ starts a signal flow on the LED bar on
the upper frontside of the CSL Elite Wheel Base and activates them to test
proper functionality of each single LED.
The button ‘Steering Wheel RevLEDs test’ starts a signal flow on the LED bar
on the Steering Wheel top side and activates them to test proper functionality
of each single LED. This is only available for Steering Wheels which have Rev-
LEDs, refer to the product description of the used Steering Wheel.
The button ‘Vibration Test’ starts a vibration signal to activate the vibration mo-
tors inside the Fanatec Steering Wheels. This is only available for Steering
Wheels which have vibration motors inside, refer to the product description of
the used Steering Wheel.
The three indicators ‘Clutch’, ‘Brake’ and ‘Throttle’ show the
current activation and position of these single pedals by a
blue bar moving up and down. Therefore the pedals must be
connected to the CSL Elite Wheel Base.
Note:
Every pedal lever must be pressed down completely to
auto-calibrate the lever movement distance each time when
power resumes.
The ‘D-pad’ arrows (up, down, left, right) change their col-
our from black to blue when the corresponding direction is
pressed on the attached Fanatec Steering Wheel.
The ‘Rotary Encoder’ boxes flash blue when turning left or
right the FunkySwitch
TM
(clockwise or counter-clockwise).
