FANATEC CSL Elite Wheel Base +, Manual

Page: 39 / 50

39
Put the H-pattern shifter lever into the position shown on the LED display and
acknowledge each single position by pressing /
START (10)
to proceed to
the next step.
The following pictures show the instructions on the LED display of the CSL
Elite Steering Wheel (PS4
TM
version) but are similar on other Fanatec
®
steering
wheels:
. . . . . . . . . . . . . . . . Neutral Position
. . . . . . . . . . . . . . . . . . . . . . .
Reverse
. . . . . . . . . . . . . . . . . . . . . . . 1
st
Gear
. . . . . . . . . . . . . . . . . . . . . . . 2
nd
Gear
. . . . . . . . . . . . . . . . . . . . . . . 3
rd
Gear
. . . . . . . . . . . . . . . . . . . . . . . 4
th
Gear
. . . . . . . . . . . . . . . . . . . . . . . 5
th
Gear
. . . . . . . . . . . . . . . . . . . . . . . 6
th
Gear
. . . . . . . . . . . . . . . . . . . . . . . 7
th
Gear
If your shifter has no 7th gear, acknowledge it by pressing / START (10)
when the shifter lever is physically in the 6th gear position. After all gears are
calibrated the LED display shows S_1 and the shifter is ready for use.
NOTE : If you did not intend to enter the shifter calibration mode sim-
ply complete the calibration process either without a connected shifter or
without moving the shifter lever. You may then leave the shifter calibra -
tion mode at the end of the process. This has no impact on the CSL Elite
Wheel Base+ original calibration itself and you can continue without a
shifter.