User manual for Operating table SU-14
Page 16
3.2
Raising and levering of table top
The height of table top is changed within the range defined in technical data by pressing the button [1]
or [2] of controller (wire-connected controller, wireless controller or side control panel). When the
extreme position is reached, table top stops automatically.
3.3
Table top longitudinal inclination
In order to change longitudinal inclination of table top (trendelenburg and anti-trendelenburg) within
the range indicated in technical data, one should press button [5] or [6] of controller (wire-connected
controller, wireless controller or side control panel). The movement lasts as long as the button is being
pressed. When an extreme position is reached, table top stops automatically.
Caution!
Angular couch position can be changed only by medical personnel. The
Trendelenburg position is a rescue position.
When performing longitudinal and side tilting functions, patient should be
secured against uncontrolled sliding down from the operating table. Use
shoulder supports, supporting rollers, side supports, belts and grips as securing
elements.
When trendelenburg function is performed, the backrest should be in zero
position or above the horizontal level so that no collisions take place!
3.4
Table top side inclination
In order to change side inclination of table top within the range indicated in technical data, one should
press button [5] or [6] of controller (wire-connected controller, wireless controller or side control panel).
The movement lasts as long as the button is being pressed. When an extreme position is reached,
table top stops automatically.
Caution!
When performing longitudinal and side tilting functions, patient should be
secured against uncontrolled sliding down from the operating table. Use
shoulder supports, supporting rollers, side supports, belts and grips as securing
elements.
3.5
Memory of table top position (zero position)
The table controller enable writing 3 any table top position in this memory. Every table top position
may have free height, longitudinal and side inclination. One of this changed position can be the zero
position of table top.
In order to write the position in memory, first should place the required position by means of function
buttons 1-6 on the controller (fig. 4). Press (just a while) the 8 function button of controller (fig. 4). Next
press one of the changed memory buttons-7 (fig. 4), which writes the preset table top position. The
proper writing of position is signalizing by meant of sound signal.
In order to receive the preset position should press one of the function buttons of controller- 7and keep
until receiving the changed position, which is until moment when the table op has been stopped.
Caution!
In the case of finding the discrepancy between preset and receive position,
one should again carry out the position preset procedure.
3.6 Change of angular position of the backrest segment
The angle of the backrest segment (fig. 1, item 2) is changed by the use of the force of muscles with
support of gas spring. In order to adjust a segment position, press blockade (fig.1, pos.20), deviate the
lever (fig. 1, pos.9) to up and then place a segment in a desired position and release a lever (fig.1,
item 9). After releasing a lever, a backrest segment mechanism is blocked and further movement is
prevented. Remember to hold a segment with both hands while adjusting position. Thanks to the
