4.6 Additional functions
4.6.1 Configuring the Z-Wave network using the ZWMA adaptive module (INCLUDE function).
Adding a device to the “Z-Wave” network is possibly only with the use of PRIMARY controller
(e.g. keyboard ZWK10, ZWK1, ZWP10, ZWPTV). The ZWMA module should be associated with the network
as SECONDARY. However, there is a possibility of programming the module for the network as PRIMARY.
The procedure of device adding to the network with the use of the ZWMA module is presented in Figure 7.
*) Programming error results from the fact of not receiving any response from the device and may be caused
by:
•
failure to press the programming button within 10 seconds from the module signalling its readiness for
adding the device to the network;
•
long distance between the module and the device being added;
•
the module has been earlier associated with the network as “SECONDARY” – it is necessary to perform
DEFAULT procedure.
13.11.21 NC825-GB
10/16
©2013,
FAKRO
Figure 7: Removing device from the Z-Wave network using ZWMA adaptive module
4
. The controller is signaling that
the device has been successfully
associated with the network (two
LEDs on for app. 2-3 sec.). For
operating accessories with the use
of the module, proceed to section
4.2.
5*
. Programming error – two
external LEDs flashing for app.
2-3 sec.
2
. The controller is signaling
its readiness for adding a new
device to the network (two
external LEDs on for 10 sec.).
3
. Press “P” button on the device and
hold it more than 0.5 sec. (see Device
Programming Manual).
1
. Press “
In/Ex
” button once.
x1
x1
>0,5Sec.
Note!!!
In the newer version of a controller, interrupting any procedure is possible by pressing the “IN/EX” button. In the older
version, it is necessary to wait 10 seconds until the error is signalled by the controller or reset it by disconnecting the power
supply.
