4 Module programming
In order to operate electric FAKRO accessories equipped with the Z-WAVE system by means of
the ZWMA adaptive module, it is necessary to:
1. Add the device to be operated by means of the module to the “Z-Wave” system – see ZWP10 remote
control and ZWK10, ZWK1 keyboards manuals, chapter “Adding device to the network (INCLUDE
function)” or other controller working in the Z-Wave system. If the device is already operated with one
of the controllers, proceed to section 2.
2. Add the module to the Z-Wave network as a SECONDARY controller, chapter 4.1 (LEARN MODE
function).
and
3. Associate the device with a selected channel in the module (No. 1,
Figure
1
) specifying the task to be
performed by it (chapter 4.2, ASSOCIATE function).
Note!!!
Any device which is physically removed from the network (e.g. damaged) should be deleted from the
memory of the controller (PRIMARY, SECONDARY), that is first deleted from the pair of buttons (section
3.4) and then removed from the network (section 3.5). The correct implementation of the procedures is to
ensure optimal communication between devices. Unplugging the device without removing it from the controller
memory will result in a prolonged reaction time to commands and faster depletion of the controller battery. If it
is necessary to remove the damaged equipment, whose removal from the controller memory is not possible, it is
desirable to reconfigure the whole network (all devices). Start a new network configuration from restoring the
controller to the factory settings (DEFAULT function), then call the EXCLUDE function of devices working
correctly and continue to the section 3, "Controller Programming".
Note!!!
Moving the device within the network (e.g. socket module) it is recommended to delete it from the
controller memory (delete it from the pair of buttons first (section 3.4) and then remove from the network
(section 3.5) and then add it again after installation in new place of work.
13.11.21 NC825-GB
5/16
©2013,
FAKRO
