1 Safety rules
Read the instructions below carefully before proceeding to device installation so as to
avoid electric shock, injury etc.
CAUTION!!!
The ZWMA module is powered by 230V alternating current. Electric shock hazard.
When installing the ZWMA module it is crucial to pay close attention to the following
recommendations:
●
Installation should be performed by a qualified individual following manufacturer's
instructions.
●
Connecting the module should be performed with power supply disconnected at all times.
●
After unpacking, check module elements for any signs of mechanical damage.
●
Before connecting the module, make sure that the power supply voltage corresponds with
that provided on the data plate.
●
Plastic containers used for packing should be kept out of children's reach as thy may be a
potential source of hazard.
●
The ZWMA module should be used for its intended purpose in agreement with its design.
The FAKRO Company shall not be held responsible for any consequences resulting from
improper module use.
●
Any activities relating to cleaning, adjustment or disassembly of the module should be
preceded with its disconnection from the mains.
●
The module should not be cleaned using any solvent substances or open stream of water
(do not immerse in water).
●
Any module repairs should be carried out by the manufacturer authorised service.
●
Electric cables supplying electricity to the source of power must have suitable area
(2x1mm
2
). The permissible cable length for the area specified above is 30 rm.
●
The permissible length of cables plugged into digital inputs is 5 rm.
●
The ZWMA adaptive module is intended for indoor installation.
13.11.21 NC825-GB
2/16
©2013,
FAKRO
