Fagor CNC 8065, Hardware Configuration

Page: 95 / 110

Hardware config urat ion
CNC 8065
9.
(R
EF
: 1404)
·95·
EMERGENCY BATTERY.
9.2 Connectors and connection.
Connector. Powering the central unit and charging the battery.
5-pin male Phoenix minicombicon contact (3.5 mm pitch).
The battery has a single connector to charge it and to power the CNC when necessary.
Status indicator LED.
The LED located next to the connector indicates the status of the battery. The LED blinks
while the battery is being charged and it stays on when the battery is charged.
Connection to the central unit.
Connect all the pins of the battery to the central unit. The battery is charged from the central
unit; DO NOT use any other device to recharge it.
5
4
3
2
1
Vbat -
Vbat +
Chassis
Vch +
Vch -
Signal Function
Vbat -
Vbat +
Central unit powered by the battery.
Chassis Shield.
Vch -
Vch +
Recharging the battery through the central
unit.
Vch -
Vbat +
Vbat -
Chassis
Vch +
Vch -
Vbat +
Vbat -
Chassis
Vch +
1
2
3
4
5
1
2
3
4
5
5
4
3
2
1
Vbat -
Vbat +
Chassis
Vch +
Vch -
5 4 3 2 1
Vb
a
t -
Vb
a
t +
Ch
a
s
s
is
Vc
h
+
Vc
h
-
Central unit Battery