Fagor CNC 8065, Hardware Configuration

Page: 46 / 110

·46·
Hard ware confi gura tion
CNC 8065
4.
(R
EF
: 1404)
CENTRAL UNI
T I
CU.
·VGA· connector.
15-pin female SUB-D HD type connector.
·IOIOI· connector. Serial line.
9-pin male SUB-D type connector.
At the CNC, the type of serial line is selected by means of the machine parameters
(parameter RSTYPE).
·PROBE· connector. Probe connection.
9-pin female SUB-D type connector.
Relay for the emergency chain.
4-pin male Phoenix minicombicon contact (3.5 mm pitch).
The relay contacts are normally open and they close when the CNC
is powered up and running properly; they open again when the CNC
is turned off or when an internal failure occurs.
These relays withstand up to 1A at 24V.
Pin. Signal.
1 RED
2 GREEN
3 BLUE
4 - - -
5 GND
6 GND_RED
7 GND_GREEN
8 GND_BLUE
Pin. Signal.
9 - - -
10 GND_SYNC
11 - - -
12 - - -
13 HSYNC
14 VSYNC
15 - - -
5
1
10
6
15
11
Pin. RS232 signal. RS422 signal. RS485 signal.
1 DCD - - - - - -
2 RxD LineTerm 120
Ω
. LineTerm 120
Ω
.
3 TxD /LineTerm 120
Ω
. /LineTerm 120
Ω
.
4 DTR - - - - - -
5 GND GND GND
6 DSR TxD TxD RxD
7 RTS /TxD /TxD /RxD
8 CTS RxD TxD RxD
9 RI /RxD /TxD /RxD
1
5
6
9
Pin. Signal. Description.
1 Chassis Shield.
2 PRB1 +5 V 5 V output for probe 1.
3 PRB1 IN5V 5 V input of probe 1.
4 PRB1 IN24V 24 V input of probe 1.
5 PRB1 GND 0 V reference input of probe 1.
6 PRB2 +5 V 5 V output for probe 2.
7 PRB2 IN5V 5 V input of probe 2.
8 PRB2 IN24V 24 V input of probe 2.
9 PRB2 GND 0 V reference input of probe 2.
5
1
9
6
1
2
3
4