Fagor CNC 8065, Hardware Configuration

Page: 35 / 110

Hardware config urat ion
CNC 8065
4.
(R
EF
: 1404)
·35·
CENTRAL UNI
T I
CU.
Voltage supply for the central unit.
Universal DC power supply. Use a 24 V DC ±10% 3.5 A power supply. See "4.5 Power
connection." on page 56.
Optionally, an external battery may be connected to ensure that the unit is properly powered
off when detecting supply voltage outages. The battery provides an autonomy of about 20
minutes when it is fully charged.
Battery-powered RAM memory (non-volatile RAM)..
The CNC has battery-powered RAM memory that keeps the information saved in it even
when a power failure occurs. The RAM memory is powered by a battery that may be
accessed from the outside. See
"4.6 Housing for the compact flash and battery-powered
RAM memory." on page 57.
The RAM memory with battery always saves the position of the axes, the rest of the data
that it saves is determined by machine parameters, like for example, PLC registers
(parameter BKUPREG), common arithmetic parameters (parameter BKUPCUP), etc.
Available monitors.
LCD monitors attached to the central unit ICU.
The central unit is located on the rear of the monitor and may be the following sizes.
Off-the-shelf VGA monitor.
An off-the-shelf VGA monitor may be connected to the central unit, but its cable cannot
exceed 10 meters.
Saving data in the battery-powered RAM required version V3.14 or higher.
i
Name. Description.
LCD-10K 10" LCD monitor (18-bit color) with integrated keyboard and operator panel.
Resolution 800x600.
LCD-15 15" LCD monitor (18-bit color).
Resolution 1024x768.
LCD-15 TOUCH 15" LCD monitor (18-bit color). Touch-screen.
Resolution 1024x768.