Fagor CNC 8065, Hardware Configuration

Page: 80 / 110

·80·
Hard ware confi gura tion
CNC 8065
6.
(R
EF
: 1404)
HORI
Z
O
NTAL
-K
EYB MODULE.
HORI
ZONTAL KEYBOARD W
ITH
OR W
ITHOUT M
O
USE.
CAN bus. Bus type selector: CANfagor / CANopen.
Switch ·1· (CAN F/O) selects the type of CAN bus to by used, i.e. CANfagor or CANOpen.
CAN bus. Selecting the baudrate for the CANopen bus.
When using the CANopen protocol, the transmission speed at the bus is defined in each node
and they all must run at the same speed. The speed is selected with switches ·2· and ·3· (CO
BR).
The transmission speed depends on the total length of the bus. Using the following illustrative
values; assigning other values may cause communication errors due to signal distortion.
In order for any change of speed to be assumed, the corresponding module must be reset;
however, we recommend to change the speed while the modules and the CNC are off.
CAN bus. ·ST· selector.
The switch position of the terminating elements must be "1" and that of the rest of the
elements "0".
Line terminating resistor. The ·LT· switch identifies which are the
elements that occupy the ends of the CAN bus; i.e. the first and last
physical element in the connection.
1 2 3 4
ON
CAN F
/O
CO
BR
ADD M
S
B
DS ·1· Type of CAN bus.
off The CANfagor bus has been selected.
on The CANopen bus has been selected.
1 2 3 4
ON
CAN F
/O
CO
BR
ADD M
S
B
DS ·2· DS·3· Speed Length of the CAN bus.
on on 1000 kHz Up to 20 meters.
off on 800 kHz From 20 to 40 meters.
on off 500 kHz From 40 to 100 meters.
off off 250 kHz From 100 to 500 meters.
0 1