Fagor CNC 8065, Hardware Configuration

Page: 13 / 110

Hardware config urat ion
CNC 8065
(R
EF
: 1404)
·13·
SAFETY CONDITIONS
Read the following safety measures in order to prevent harming people or damage to this product and those
products connected to it. Fagor Automation shall not be held responsible of any physical damage or
defective unit resulting from not complying with these basic safety regulations.
PRECAUTIONS BEFORE CLEANING THE UNIT
PRECAUTIONS DURING REPAIR
In case of a malfunction or failure, disconnect it and call the technical service.
PRECAUTIONS AGAINST PERSONAL DAMAGE
Before start-up, verify that the machine that integrates this CNC meets the 89/392/CEE Directive.
Do not get into the inside of the unit. Only personnel authorized by Fagor Automation may manipulate the
inside of this unit.
Do not handle the connectors with the unit
connected to AC power. Before handling these connectors (I/O, feedback, etc.), make sure
that the unit is not powered.
Do not get into the inside of the unit. Only personnel authorized by Fagor Automation may manipulate the
inside of this unit.
Do not handle the connectors with the unit
connected to AC power. Before handling these connectors (I/O, feedback, etc.), make sure
that the unit is not powered.
Interconnection of modules. Use the connection cables provided with the unit.
Use proper cables. To prevent risks, only use cables and Sercos fiber recommended for
this unit.
To prevent a risk of electrical shock at the central unit, use the proper
connector (supplied by Fagor); use a three-prong power cable (one
of them being ground).
Avoid electrical overloads. To prevent electrical shock and fire risk, do not apply electrical voltage
out of the indicated range.
Ground connection. In order to avoid electrical discharges, connect the ground terminals
of all the modules to the main ground terminal. Before connecting the
inputs and outputs of this unit, make sure that all the grounding
connections are properly made.
In order to avoid electrical shock, before turning the unit on verify that
the ground connection is properly made.
Do not work in humid environments. In order to avoid electrical discharges, always work under 90% of
relative humidity non-condensing at 45ºC (113ºF).
Do not work in explosive environments. In order to avoid risks or damages, do no work in explosive
environments.