Fagor CNC 8058elite T, Manual

Page: 70 / 90

Probing (·T· model).
CNCelite
8058 8060
8065
4.
CANNED CYCLES. CYCLE EDITOR.
Too
l ca
lib
ra
tion.
ꞏ70ꞏ
R
EF
. 2106
1 The cycle selects the programmed tool.
2 The CNC runs the subroutine Sub_Probe_Tool_Begin.fst, defined by the OEM.
3 The cycle executes the "M-before" functions.
4 Approach movement.
Rapid probe movement (G00) from the cycle calling point to the approach corner. This
point is located in front of the associated probe corner, at a ꞏDsꞏ distance from it.
This approach movement is made in two stages. It first moves along the Z axis and then
along the X axis.
5 Probing movement.
The sides of the probe used in this probing move as well as the path traveled by the tool
depend on the location code assigned to the selected tool. When having a "Trihedron"
type geometrical configuration and three-axis probing has been defined, it will execute
an additional probing move on the Y axis.
Each probing move will consist of an approach move, a probing move per se and a
withdrawal move.
Approach movement. Rapid probe move (G00) to the approach point located in front of
the side to be probed at a ꞏDsꞏ distance from it.
Probing movement. Probing movement at the indicated feedrate (F) until the probe signal
is received. The maximum probing distance is ꞏ2Dsꞏ. If the CNC does not receive the
probe signal before reaching moving this probing distance, it stops the axes and displays
the relevant error message.
Withdrawal movement. Rapid probe movement (G00) from the probing point to the
approach corner.
6 Withdrawal movement.
Rapid probe movement (G00) from the approach corner to the cycle calling point.
This withdrawal movement is made in two stages. It first moves along the X axis and then
along the Z axis.
7 The cycle executes the "M-after" functions.
8 The CNC runs the subroutine Sub_Probe_Tool_End.fst, defined by the OEM.
Ds
Ds
X+
Z+
P
C
F5
X+
Z+
P
C
F3