Fagor CNC 8058elite T, Manual

Page: 77 / 90

Probing (·T· model).
CNCelite
8058 8060
8065
CANNED CYCLES. CYCLE EDITOR.
4.
Part mea
su
ring al
ong
the ordi
nate axis.
ꞏ77ꞏ
R
EF
. 2106
4.4 Part measuring along the ordinate axis.
This cycle measures the part along the ordinate axis. With this cycle, it is also possible to
correct the value of the wear of the tool used to machine the surface. The wear correction
only takes place when the measuring error exceeds a programmed value.
For this cycle, a probe mounted in the tool holding spindle must be used, it must be previously
calibrated with the tool calibration canned cycle.
Data returned by the cycle after the measurement.
Once the cycle has ended, the CNC returns the real values obtained in the measurement
in the following arithmetic parameters:
If wear correction is enabled in the calling instruction, the CNC updates those values in the
programmed tool. This correction is applied only if the measuring error is equal to or greater
than the programmed tolerance.
P298 Actual (real) surface coordinate.
This value is given in the active units, radius or diameter.
P299 Detected error. Difference between the actual surface coordinate and the
programmed theoretical coordinate.
This value is given in radius.