Fagor CNC 8058elite T, Manual

Page: 84 / 90

Probing (·T· model).
CNCelite
8058 8060
8065
4.
CANNED CYCLES. CYCLE EDITOR.
Pa
rt m
ea
su
ring
a
lo
ng
the abscissa axis.
ꞏ84ꞏ
R
EF
. 2106
4.5.2 Basic operation.
In the following description, the Z axis is the abscissa axis and the X axis is the ordinate axis.
1 The cycle selects the programmed tool.
2 The CNC runs the subroutine Sub_Probe_Piece_Begin.fst, defined by the OEM.
3 The cycle executes the "M-before" functions.
4 Approach movement.
Rapid probe movement (G00) from the cycle calling point to the approach point. This
point is located in front of the point being measured, at a ꞏDsꞏ distance from it.
This approach movement is made in two stages. It first moves along the X axis and then
along the Z axis.
5 Probing movement.
Probing movement along the Z axis at the indicated feedrate (F) until the probe signal
is received. Once probing has been made, the CNC will assume as their theoretical
position the real position of the axes when the probe signal is received .
The maximum probing distance is ꞏ2Dsꞏ. If once this distance has been reached, the CNC
has not yet received the probe signal, it will issue the relevant error code and stop the
movement of the axes.
6 Withdrawal movement.
Rapid probe movement (G00) from the probing point to the cycle calling point.
This withdrawal movement is made in two stages. It first moves along the Z axis and then
along the X axis.
7 The cycle executes the "M-after" functions.
8 The CNC runs the subroutine Sub_Probe_Piece_End.fst, defined by the OEM.
Ds
Ds
1
2
3
1
3
Z
X