6.2 Cleaning programme diagram
Only available when activated in parameters
Switch-on delay for heater
Post-heating temperature during main circulation
Cleaning pump venting (if set in parameter [r80])
and 6.1.4
Only required in case of cleaning method ‚green' (see section 6.1.3
).
n
n11
D
H
Cleaning cycles, cleaning stages
and programme steps:
A cleaning cycle consists of different
"
".
cleaning stages
Each cleaning stage consists of sev-
eral 'programme steps'.
programme step
Designation of the
, with which the corresponding times are set
n-parameters
For the first parameter of each cleaning stage the following can be parameterised: Water intake by level
Adjustment of dosing times for detergents
Heat-up time (variable - until the set temperature is reached)
During the cleaning process the current
programme step is displayed.
The flashing point indicates activity.
6. Cleaning
Level 1
Level 2
Level 1
Level 2
Level 1
Level 2
Level 1
Level 2
Cleaning cycle
Clean. stg 0
Cleaning stage 1
Cleaning stage 2
Cleaning stage 3
Cleaning stage 4
Rinse out
Pre-rinse 1
Pre-rinse 2
Main rinse 1
Intermediate rinse 1
agitator
compressor
cold water valve
warm water valve
alk. detergent
acid detergent
drain valve
cleaning pump
heater
cleaning active
disinfection
T1
T2
°C
Page 20
Summary of Contents for DARI-KOOL GALA-KOOL Pro
Page 29: ...Page 29...
