FAAC E1SL, Manual, Page: 6 / 52

5
E1SL 6 532258 04 - Rev. B
0.0
RESET/SETUP
DL2
DL11
MAIN
F1
USB
+
- F
ERR
BAT1
OPEN
EMERG
BAT2
SIC_OP
SIC_CL
J10
J14
J11
J12 J13
V G
S1
G
T
J1
J17
V RX
TX G
J8
E1 G E2 J7
T1 G
T2
R1
G R2
J9
V G 01 02 02
J22
J21
V
G
I1
I2
G
I3
I4
V
J18
G CH CL
G
J23 J24
J25
V G
S2
G
T
J4
1
2
3
4
5
4
Tr
ansla
tion of the original instruc
tions
ENGLISH
A DM board must be installed on automations fitted with a double
motor.
INSTALLING THE DM BOARD
!
Before proceeding, disconnect the mains power supply and disconnect
the emergency battery (if present).
1. Remove the E1SL board: remove all the connections, the screw
( 1 ) and the screw with washer ( 2 ), then remove the board from
the support ( 3 ).
2. Unscrew the 2 screws ( 4 ) and remove the plastic cap, pulling out
the 2 pins ( 5 ).
3. Install the DM board Refer to
6
, install the 4 posts ( 6 ) on the E1SL
board and fasten them using the screws provided ( 7 ). Insert the
2 comb connectors into the connectors of the E1SL board as far as
the connector (
8 ). Insert the DM board ( 9 ) on the side opposite
the comb connectors, as far as the connector ( 8 ). Fasten the DM
board onto the 4 posts using the screws provided ( 10 ).
4. Replace the plastic cap, inserting the 2 pins ( 5 ) into the board
E1SL. Fasten it using the 2 screws ( 4 ).
5. With reference to
5
, Reinstall the E1SL board into the seats
( 3 ). Fix in position with the screw ( 1 ) and the screw with washer
( 2 ). IMPORTANT : the washer provides the board's earth connection.
6. Restore all connections.
CONNECTING THE SECOND MOTOR
1. Extend the motor cable using the cable with connector and the
terminal connector provided.
2. With reference to
7
, insert the connector ( 11 ) onto the board
DM ( 12 ). Follow the colour coding of the wires.
ENABLING THE DM KIT
During programming:
- from Board , advanced programming:
dM
=
Y
or
- from SDK EVO :

/ PROGRAMMING / INSTALLATION / 2ND ENGINE KIT = ENABLED
Removing/reinstalling the E1SL board
Removing/reinstalling the cap
2. DM BOARD