8
9
B614
18
532297 - Rev.D
.86 in
B614 door
side
arm side
4.2 INSTALLING THE FOUNDATION PLATE
F
Always perform the work with the power supply
disconnected.
!
The barrier installation is facilitated by the use the
optional foundation plate.
- The blueprint appended to this manual that gives the
characteristics of the foundation is approximate. The
bluprint considers the barrier applied to the maximum
limits indicated in this manual and under the most
arduous conditions. The installation engineer is
responsible for the evaluation of the foundation mate-
rials and dimensions on the basis of the characteristics
of the ground and place of installation. Perform
structural calculations where necessary.
1. Dig the hole in the ground. Fill it with concrete,
allowing the cable conduits to protrude.
2. (
8
) Assemble the base plate.
3. (
9
) Immerse the base plate in the foundation
leaving the surface exposed.
!
The plate must be in the centre of the plinth.
The hole for the cables to pass through must corre-
spond with the orientation planned for the barrier
(barrier side, door side).
The cable conduits must protrude from the hole in the
plate by approximately 8 in (20 cm).
Check the plate is horizontal using a level.
Clean the concrete off the surface of the plate and
the nuts with washers so they can be removed when
necessary.
4. Wait for the concrete to set.
Summary of Contents for B614
Page 1: ...B614...
