10
11
12
B614
19
532297 - Rev.D
19
50 Nm
4.3 INSTALLING THE BARRIER BODY
F
Always perform the work with the power supply
disconnected.
!
Before you start, make sure that the plinth's concrete
has solidified.
In this phase the barrier must be locked.
Never handle the barrier by holding the control
board support.
1. (
10
) Remove the 4 nuts with washers from
the plate
2. (
11
) Place the barrier body on the foundation,
at the four mounting holes.
!
Be careful not to damage the electrical cable conduits.
3. (
12
) Fix the body of the barrier in position using
a nut with washer on every bolt of the foundation.
!
Use the torque wrench to tighten to the torque shown
in the figure.
Summary of Contents for B614
Page 1: ...B614...
