15
Fig. 26
Fig. 27
Fig. 28
Fig. 24
7.
FINAL OPERATIONS
After completing installation, remove the breather screw (see
fig. 24) and apply the danger signal tape on the top of the
cover (Fig. 25).
Fit the side panels by pressure, and secure the cover with the
supplied screws.
Hand the “User’s Guide” to the Client, explain correct operation
and use of the gear motor, and indicate the potentially
dangerous areas of the automated system.
8.
MANUAL OPERATION
If the gate has to be moved manually due to a power cut or
fault of the automatic system, use the release device as follows:
1) Open the protective door and fit the supplied key in the
lock (Fig. 26).
2) Turn the key clockwise and pull the release lever as shown in
Fig. 27.
3) Open and close the gate manually.
9.
RESTORING NORMAL OPERATION MODE
To prevent an involuntary pulse from activating the gate during
the manoeuvre, cut power to the system before re-locking the
operator.
1)
Re-close the release lever.
2)
Turn the key counter-clockwise.
3)
Remove the key and close the lock protection door.
4)
Move the gate until the release device meshes.