F.W. Bell 7030, Instruction Manual

Page: 47 / 126

F.W. BELL Model 7030 Gauss/Tesla Meter Instruction Manual
Section 5 – User Interface 5-9
DISPLAY FORMAT
The instrument will automatically format the screen for the best
possible view based on the number of channels active and
parameters enabled. It is possible to have all three channels and
the vector summation active at the same time. The orientation may
be horizontal or vertical. If any channels are deactivated, the
remaining channels will automatically enlarge to fill the screen.
Table 5-2 summarizes the various display options.
Table 5-2 Display Options
Parameter Displayed Scope Comments
Present Flux Density Always
All Active Channels,
and Vector Summation
Larger Than All Other parameters
Range Always All Active Channels
AC/DC Always All Active Channels
Temperature Optional Specific Active Channels
Enabled from DISPLAY Menu
(Temperature Compensated Probes only)
Frequency Optional Specific Active Channels
Enabled from DISPLAY Menu
( ac Mode Only)
Angle Optional Vector Summation Only Enabled from DISPLAY Menu
Relative Optional Specific Active Channels
Enabled from RELATIVE Menu or
Front Panel Keypad
Hold
Minimum Optional
Specific Active Channels,
and Vector Summation
Display of these parameters are selected
from the HOLD menu. However the
selected parameters are displayed only
when the HOLD key on the front panel is
activated.
Maximum Optional
Specific Active Channels,
and Vector Summation
Peak Optional Specific Active Channels
Valley Optional Specific Active Channels
Date Optional
Lower Portion of Screen Enabled and Set from DISPLAY Menu
Time Optional