F.W. Bell 7030, Instruction Manual

Page: 46 / 126

F.W. BELL Model 7030 Gauss/Tesla Meter Instruction Manual
5-8 Section 5 – User Interface
Table 5-1 Default Configuration Settings
Menu Item Setting Scope
HOLD
Maximum Enabled All Channels and Vector Summation
Minimum Enabled All Channels and Vector Summation
Peak Enabled All Channels
Valley Enabled All Channels
FILTER
Analog Filter AUTO All Channels
Update Interval 1.0 Sec All Channels
DISPLAY
Channel on Enabled All Channels and Vector Summation
Frequency Enabled All Channels
Temperature Enabled All Channels ( If Supported by Probe )
Angle Enabled Vector Summation
Orientation Vertical Measurement Screen
Date and Time Enabled Measurement Screen
RELATIVE
Active Disabled All Channels
Scale 1 All Channels
Value +0.00000 T All Channels
UNITS
Flux Density tesla (T) All Channels and Vector Summation
Temperature celsius (
°
C) All Channels
Angle Radians (rad) Vector Summation
Time Frequency (Hz) All Channels
COMMUNICATIONS
RS232 Disabled
Baud Rate 19200
Parity None
Data Bits 8
Stop Bits 1
Handshake None
Mouse Disabled
IEEE 488 (GPIB)
Address
15
ANALOG OUT
Uncorrected Output
Scale
3 V All Channels
Corrected Output
Scale
3 V All Channels
CLASSIFIER
Active Disabled All Channels
High Value +0.00000 G All Channels
Low Value +0.00000 G All Channels