Ezgo SHUTTLE 4, Owner'S Manual And Service Manual

Page: 28 / 64

*$62/,1(32:(5('3(56211(/&$55,(56 *2/)&$5
Page 8
Owner’s Manual and Service Guide
Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Use extra caution when towing vehicle.
Do not tow in excess of 12 mph (19
kph). Towing vehicle at above recommended speed may result in
damage to vehicle and other property.
Tow bars are not intended for road use.
Tow bars are designed to tow only one vehicle at a maxi-
mum speed of 12 mph (19 kph). Tow bars are not
intended for highway use. Before towing, place direction
selector in neutral and engage neutral lock. Do not ride
on vehicle being towed.
Neutral Lock
To prevent the driven clutch from turning the rear wheels
during service operations, a neutral lock is located on the
rear axle (Ref. Fig. 11 on page 8).
To operate, place the direction selector in the position
between ‘F’ and ‘R’. Turn the key switch to ‘OFF’. Rotate
the pin on the transmission shift lever as shown. The pin
will snap into a cavity in the transmission housing. When
in this position, the transmission remains locked in the
neutral position. To operate the transmission, pull the pin
out and rotate until the pointed portion of the pin handle
fits into the detent position in the transmission shift lever.
LIFTING THE VEHICLE
Tool List Qty. Required
Floor jack .................................................................... 1
Jack stands ................................................................. 4
Chocks ........................................................................ 4
Some servicing operations may require the front wheels,
the rear wheels, or the entire vehicle be raised.
To prevent possible inju-
r y o r d e a th r e s u l t i n g
from a vehicle falling
from a jack, be sure the vehicle is on a firm and level
surface. Never get under a vehicle while it is support-
ed by a jack. Use jack stands and test the stability of
the vehicle on the stands. Always place chocks in
front and behind the wheels not being raised. Use
extreme care since the vehicle is extremely unstable
during the lifting process.
When lifting vehicle, position jacks and
jack stands only on the areas indicated.
To raise the entire vehicle, install chocks in front and
behind each front wheel (Ref. Fig. 12 on page 8). Center
the jack under the rear frame crossmember. Raise the
vehicle and locate a jack stand under the outer ends of
the rear axle.
Lower the jack and test the stability of the vehicle on the
two jack stands.
Fig. 11 Neutral Lock
Locked
Position
Unlocked
Position
Pull out and rotate 180
to lock
o
Long Tab
Short Tab
Unlocked
Locked
Pull out and rotate 180
to unlock
o
1
2
1
2
Fig. 12 Lifting the Vehicle
! !
View From Underside Of Vehicle
Center of
Front Axle
Flat Portion
of Frame
Outside End
of Rear Axle