Ezgo REFRESHER 1200, Owner'S Manual

Page: 22 / 146

OPERATION AND SERVICE INFORMATION
Page 2
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
a golf course may expose operator to possi-
bility of being struck by a golf ball. Always
operate vehicle with windshield in place.
Insert two bumpers (item 17) and four grommets (item
18) into holes in windshield (item 19) as shown (Ref Fig.
2 on page 3). Position windshield and mirror brackets
(item 20) as shown. Secure windshield and mirror brack-
ets to front strut with four 1/4 - 20 X 1 3/4" bolts (item 21),
four spacers (item 22), four 1/4" washers (item 23) and
four 1/4 - 20 lock nuts (item 24). Tighten hardware firmly.
Thread mirrors (item 25) onto mirror brackets and tighten
securely.
CANOPY FRAME INSTALLATION
Orient the two canopy frame sections end to end aligning
five existing mounting holes as shown (Ref Fig. 3 on
page 4) and fasten together with five 1/4 - 20 X 2" bolts
(item 26), ten 1/4" flat washers (item 27) and five 1/4 - 20
lock nuts (item 28). Orient the assembled canopy frame
as shown and rest front of frame on top mounting plate
and rear of frame on refreshment unit struts. Secure can-
opy frame to refreshment unit struts with two 1/4 - 20 X 1
1/4" bolts (item 29), four 1/4" flat washers (item 30) and
two 1/4 - 20 lock nuts (item 31) as shown. Secure canopy
frame to front strut with two 1/4 - 20 X 2" bolts (item 32),
four 1/4" flat washers (item 33) and two 1/4 - 20 lock nuts
(item 34) as shown. Tighten hardware firmly.
CANOPY INSTALLATION
Wipe canopy frame with a clean cloth. Unfold canopy
and locate clearance openings in the mounting flap.
Drape canopy over frame and orient canopy on frame so
that clearance openings match strut attachment points
and canopy frame juncture (Ref Fig. 3 on page 4). With
the aid of assistants, pull canopy taut over canopy frame.
Fold mounting flap up inside canopy frame as shown.
Secure each mounting flap to inner surface of canopy
frame with #10 X 1/2" self tapping screws (item 35)
evenly spaced approximately 9" apart as shown. To pre-
vent “gathering” of canopy material during installation,
use the aid of assistants to hold the canopy taut while
securing to canopy frame. For best results, begin secur-
ing the canopy at the middle of each side and proceed to
each end of frame.
Fig. 1 Mounting the Refreshment Unit
1
2
Hielo
(sólo este compartimento)
Accesorios de la unidad
para refrescos:
Placas señalizadotas
Bandeja para condimentos
Carro para bebidas
Carro para botellas
Humidor
Montaje para máquinas
de tarjetas de crédito
Caja registradora
Ref Rfi 1