Extron electronics VN-Matrix 250 Series, User Manual

Page: 81 / 140

6. If RTP multicast source streaming is required, select the
Multicast Enable
box (see
figure 55 ,
4
on the previous page). If RTP unicast is required, ensure the box is not
selected.
ATTENTION:
• Use the same transport type for all streams. Check that the
Multicast Enable
setting on the data tab is the same as that on the video (see step 14 on
page 68).
• Veuillez utiliser le même type de transport pour tous les flux. Vérifiez que le
paramètre « Multicast Enable » sur l’onglet de données soit le même que sur la
vidéo (voir
étape 14 , page 68).
7. Click the
Save All
tab (see figure 55 , 5 ).
8. Encoder setup is now complete. Repeat this procedure for each encoder in the system.
Configuring a VND 250
1. Ensure that an HDMI display device is connected to the decoder (see Video
Connections on page 21).
2. If required, ensure that the analog program audio output is connected (see Audio
Connections on page 22).
3. If required, ensure that the return audio input is connected.
4. Open the VNM 250 GUI (see page 34).
5. In the Device List (see page 36), click on the VND 250 you wish to configure. The
Device
tab opens. More information can be found about the Device List tab (on
page 36) and the Decoder Device tab (on page 58).
6. Ensure the
Mode
is set to
enable
in the
Device Setup
panel (see figure 56,
1
):
1 1
2 2
Figure 56. Device Setup Panel
7. Configure the on-screen text overlay, as required ( 2 , and see Device Setup on page
58).
8.
Click the
Save All
tab.
VNM 250 • Configuration with the VNM 250 GUI 73