Humidity and water
Do not install or operate the VNM 250 in an area:
•
where the ambient relative humidity exceeds 85%
•
that is prone to condensation
•
near water or in a location that may be prone to water
Mounting Procedures
WARNINGS:
•
This equipment must be grounded.
•
Cet équipement doit être fixé au sol.
•
To avoid the possible risk of electric shock or product damage due to
condensation, always allow the power supply to adapt to the ambient temperature
and humidity for at least 30 minutes before switching it on. This is particularly
important when moving the unit from a cold location to a warm location.
•
Afin d’éviter un risque éventuel de choc électrique ou d’endommagement du
produit dû à la condensation, laisser toujours le temps à la source d’alimentation
de s’adapter à la température et à l’humidité ambiantes, pendant au moins
30 minutes, avant de les brancher. Ceci est particulièrement important lorsque vous
déplacer l’unité depuis un lieu frais vers un lieu chaud.
For tabletop use, affix one of the supplied self-adhesive rubber feet to each corner of the
bottom of the unit.
The VNM 250 Series encoders and decoders are housed in rack mountable, 1U high, metal
enclosures. Optional mounting hardware lets you install the unit in any standard 19-inch
rack or under or through furniture.
Mount the unit in a rack or under or through furniture in accordance with the directions
included with the mounting kit.
UL Rack-Mounting Guidelines
The following Underwriters Laboratories (UL) requirements pertain to the installation of the
VN-Matrix 250 into a rack.
Elevated operating ambient temperature
— If the equipment is installed in a closed or
multi-unit rack assembly, the operating ambient temperature of the rack environment may
be greater than room ambient temperature. Therefore, consider installing the equipment
in an environment compatible with the maximum ambient temperature (Tma = +122 °F
[+50 °C]) specified by Extron.
Reduced air flow
— Install the equipment in a rack so that the amount of air flow required
for safe operation of the equipment is not compromised.
Mechanical loading
— Mount the equipment in the rack so that uneven mechanical
loading does not create a hazardous condition.
Circuit overloading
— When connecting the equipment to the supply circuit, consider
the effect that circuit overloading might have on overcurrent protection and supply wiring.
Consider equipment nameplate ratings when addressing this concern.
Reliable earthing (grounding)
— Maintain reliable grounding of rack-mounted equipment.
Pay particular attention to supply connections other than direct connections to the branch
circuit (such as use of power strips).
VNM 250 • Mounting
131
Summary of Contents for VN-Matrix 250 Series
Page 6: ......
