Installing Cable Retractors (Optional)
Extron cable retractors retract and neatly store cables in Cable Cubby systems, preventing them
from tangling underneath the table. Retractor kits are available for many cable types. Up to six
retractors can be installed in the TLP Pro 725C enclosure (three on each end). They are not
provided with the touchpanel and must be purchased separately.
It is difficult to mount the Cable Cubby into the table after the Retractors have been installed so
Extron recommends the following procedure:
e
21-
525
-01
LF
21-
526
-01L
F
Insert Retractors into
the Retractor bracket.
Slide the bracket
into the enclosure
as shown
(either side).
1
3
4
Secure the bracket
with the included
screws and washers.
2
Secure the Retractors
with the included
mounting pin and clip
Secure the locking screw
on each Retractor. Do not
overtighten.
5
Figure 11.
Installing Cable Retractors
1.
Slide the Retractor bracket
into the enclosure (see
figure 11,
1
).
2.
Secure the bracket to the
enclosure with the provided
#6-32 pan-head screws and
star washers (
2
).
3.
Mount the enclosure into the
table (see
Mounting the TLP
Pro 725C Enclosure
on the
previous page).
figure 11
To mount the retractors horizontally and for further information and installation instructions,
see the
Retractors User Guide
, which is available at
www.extron.com
. The guide also
provides information about mounting the retractors at a 30° angle to satisfy ADA compliance
requirements.
4.
From under the table, insert
the Retractors into the
bracket (
3
) and secure them
with the mounting pin and clip
(
4
).
5.
Secure the locking screw on
each Retractor (
5
).
TLP Pro 725C Series Touchpanels • Mounting
15
