E
Activation Switch
(see
figure 12
on the previous page) – the left side of the lid hinge
mechanism contains a switch. When the lid is closed, the switch sends the screen into sleep
mode. When the lid is opened, the screen display is restored and active.
When the lid is shut, the screen is not activated by motion near the touchpanel.
F
Speaker
— A single speaker, located on the side of the enclosure, provides audible
feedback for the user.
In addition, the hinge mechanism for the lid contains a switch (not shown). When the lid is
closed, the screen enters sleep mode, but does not respond to motion near the touchpanel.
When the lid is opened, the screen display is restored and active.
TLP Pro 725C Base Features
e
e
LAN / PoE
275 mA
USB
RESET
MENU
D
D E
E
A
AB
B C
C
Figure 13.
TLP Pro 725C Base Panel
A
Menu button
— Pressing the
Menu
button activates the setup menu (see
Setup Menu
on
the next page).
B
Reset button
— Pressing the
Reset
button allows the unit to be reset in any of three
different modes and can also be used to toggle between enabling and disabling the DHCP
client (see
Reset Modes
).
C
Reset LED
— Provides feedback about the reset status when the user presses the
Reset
button (see
Reset Modes
on page 30).
D
USB port
— Compatible with USB 2.0.
E
LAN/PoE port
— The TLP Pro 725C must be powered by a PoE power injector through
this port. Connect the touchpanel to a PoE power injector using a twisted pair cable,
terminated with an RJ-45 connector. Connect the power injector to the LAN through a
nework switch.
The network port has two LEDs. The green LED lights steadily to indicate that the
touchpanel is connected correctly to a network. The yellow LED blinks to indicate that data
is being passed to or from the touchpanel.
NOTE:
The power injector must be purchased separately.
ATTENTION:
•
The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 725 and the Canadian Electrical
Code part 1, section 16.
•
Cette installation doit toujours être conforme aux dispositions applicables du Code
américain de l’électricité (National Electrical Code) ANSI/NFPA 70, article 725, et du
Code canadien de l’électricité, partie 1, section 16.
•
The power supply shall not be permanently fixed to building structure or similar
structure.
•
La source d’alimentation ne devra pas être fixée de façon permanente à une
structure de bâtiment ou à d’autres structures similaires.
•
Power over Ethernet (PoE) is intended for indoor use only. It is to be connected only
to networks or circuits that are not routed to the outside plant or building.
•
L’alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur
uniquement. Elle doit être connectée seulement à des réseaux ou des circuits qui ne
sont pas routés au réseau ou au bâtiment extérieur.
Activation Switch
Speaker
figure 13
Menu button
Reset button
Reset LED
USB port
LAN/PoE port
Attention
mise en garde
TLP Pro 725C Series Touchpanels • Panel Features
17
