MKP 2000 • Remote Control
25
Error Messages
When the MKP receives an SIS command and determines that it is valid, it performs the
command and sends a response to the host device. If the MKP is unable to perform the
command because the command is invalid or contains invalid parameters, the MKP returns
an error response to the host. The error response codes are:
E01
— Invalid input channel number (too large)
E10
— Invalid command
E12
— Invalid output number (too large)
E13
— Invalid value (out of range)
E14
— Illegal command for this configuration
E24
— Privilege violation (Ethernet, Extron software only)
E99
— Invalid or no response from target switcher
Using the Command and Response Tables
When programming in the field, certain characters are most conveniently represented by
their hexadecimal rather than their ASCII values. Lowercase letters are acceptable in the
command field except where indicated for the gain and attenuation commands. The table
below shows the hexadecimal equivalent of each ASCII character:
ASCII to Hex Conversion Table
•
Space
Figure 27.
ASCII to Hex Conversion Table
The MKP always redirects a subset of valid matrix switcher-specific SIS commands on its
Ethernet port and, if configured in pass-through mode, on its Switch RS-232 port.
NOTE:
It is not the purpose of this manual to define in detail the passed-through matrix
switcher-specific SIS commands. Refer to the applicable matrix switcher’s manual.
Symbols are used throughout the tables to represent variables in the command/response
fields. Command and response examples are shown throughout the MKP SIS commands
table.
figure 27
Summary of Contents for MKP 2000
Page 1: ...User Guide MKP 2000 Matrix Switchers Remote Control Panel 68 971 01 Rev E 01 19 ...
Page 6: ......
Page 8: ...MKP 2000 Contents viii ...
Page 56: ......
