Extron electronics MKP 2000, User Manual

Page: 29 / 56

MKP 2000 • Operation 21
Control Panel Security Lockout (Executive Mode)
The MKP 2000 provides the following three levels of front panel security lockout (executive
modes):
• Panel Locked mode — All front panel controls are locked. Selections and setup
cannot be performed from the front panel.
• User mode — Front panel operation is limited to input and output selection. The panel
configuration, IP, and switcher addressing functions are locked.
• Administrator mode (default) — All front panel controls are available.
To step through the selections for the three executive modes:
1. Press and hold the
1
,
3
,
Back
, and
Cancel
buttons until the LED window displays
one of the following messages, indicating the executive mode that has been set
(approximately 3 seconds).
•
Administrator mode — The LED display flashes
LOC
, then
Ad
; then displays
"
...
".
•
User mode — The LED display flashes
LOC
, then
Us
; then displays "
...
".
•
Panel Locked mode — The LED display shows
LOC
.
2. Repeat step 1 until the LED indicates the mode you want.
1 3
BACK CANCEL
LOC Ad
. . .
Simultaneously press
and hold these buttons.
The LED display flashes the
LOC, then Ad messages.
3
seconds
The “. . .” message
remains for
approximately 10
seconds
Figure 23. Control Panel Lockout: Switching to Administrator Mode
Rear Panel Resets
Performing Soft Resets
The remote control panel has three soft resets available that restore various tiers of MKP
settings to their defaults.
• Events (mode 3) reset — Restarts the communications and control events.
• IP system (mode 4) reset — Resets most IP protocols to their default settings.
NOTE:
IP system reset clears the Internet protocol (IP) settings, but does not reset
the target address, the host control setting, the priority setting, or any user-loaded
files.
• Absolute (mode 5) reset — Performs all of the system reset functions and clears the
MKP IP address to
192.168.254.253
and subnet mask to
255.255.0.0
. This function
is identical to the E
ZQQQ
]
SIS command (see Reset on page 28).
To perform a soft reset of the MKP 2000:
1. Press and hold the
Reset
(
R
) button until the
Reset
LED blinks off once (for events
reset), twice (for IP system reset), or three times (for absolute reset) (see figure 24 on
the next page).
figure 23