Extron electronics MKP 2000, User Manual

Page: 30 / 56

MKP 2000 • Operation 22
R
R
R
R
R
R
R
R
R
6
seconds
LED flashes
twice.
3
seconds
LED flashes
once.
Press and hold
the Reset button. Release, then
immediately
press and
release again.
Release, then
immediately
press and
release again.
Release, then
immediately
press and
release again.
Absolute
(mode 5)
Reset
Press and
hold
the Reset button.
IP System
(Mode 4)
Reset
Press and
hold
the Reset button.
Events
(Mode 3)
Reset
9
seconds
LED flashes
three times.
Figure 24. Performing Soft Resets
2.
Release the
Reset
button and then immediately press and release the
Reset
button
again. Nothing happens if the second momentary press does not occur within
1 second.
Performing a Hard Reset
The hard reset function restores the MKP to its original factory default firmware configuration
and erases all user-installed software or firmware.
Follow these steps to perform a hard reset:
ATTENTION: Ensure that you have backed up any locally-created HTML, JavaScript,
or other files that have been uploaded to the MKP user file space before you perform
the hard reset. A hard reset will erase all locally-created files from the MKP.
NOTE: The hard reset does not change the IP address, the subnet mask, the gateway
address, or the matrix switcher IP address.
1. Turn off power to the switcher.
2. Press and
Hold
the
Reset
button on the rear panel while you apply AC power to the
MKP (see figure 25).
Power
R
R
Press and hold the
Reset button while you
apply power to the MKP.
The LED flashes
on and off.
Release the Reset button.
Figure 25. Performing a Hard Reset
figure 24
figure 25