Extron electronics MKP 2000, User Manual

Page: 21 / 56

MKP 2000 • Installation 13
The cable that you use depends on your network speed. The MKP supports both 10 Mbps
(10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex and full-
duplex, Ethernet connections.
• 10Base-T Ethernet requires CAT 3 UTP or STP cable as a minimum.
• 100Base-T Fast Ethernet requires CAT 5e UTP or STP cable as a minimum.
The Ethernet cable can be terminated as a straight-through cable or a crossover cable, and
must be properly terminated for your application.
• Patch (straight-through) cable — Network connection between the MKP and an
Ethernet LAN (see figure 12 on page 11)
• Crossover cable — Direct connection between the MKP and a host computer or an
Ethernet-enabled matrix switcher (see figure 11 on page 11).
Clip Down Side
1
1&2
3&6 4&5 7&8
2345678
1 Pins 2345678
RJ-45
connector
Twisted
Pairs
Patch (straight) cable Crossover cable
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-green
2 Orange 2 Green
3 White-green 3 White-orange
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Orange
7 White-brown 7 White-brown
8 Brown 8 Brown
Side 1 Side 2
Pin Wire color Pin Wire color
1 White-orange 1 White-orange
2 Orange 2 Orange
3 White-green 3 White-green
4 Blue 4 Blue
5 White-blue 5 White-blue
6 Green 6 Green
7 White-brown 7 White-brown
8 Brown 8 Brown
Figure 15. RJ-45 Connector and Pinout Tables
Power Supply Wiring
A 12 VDC, 0.5 A power supply is provided with the MKP 2000 transmitter. Follow these
instructions to wire the 2-pole captive screw connector to your power supply:
CAUTION:
Risk of minor personal injury:
ATTENTION : Risque de blessure mineure :
• The DC output cables must be kept separate from each other while the power
supply is plugged in. Remove power before wiring.
• Les câbles de sortie CC doivent être séparés les uns des autres tant que la
source d’alimentation est branchée. Coupez l’alimentation avant d’effectuer les
raccordements.
•
The length of exposed wires is critical (see the
ATTENTION notifications
on the
next page for details).
• La longueur des câbles exposés est primordiale lorsque l’on entreprend de
les dénuder. (voir les deux premières
ATTENTION en page suivante pour plus
d’informations).
figure 15