![Extron electronics DTP2 R 212 Series User Manual Download Page 16](http://html1.mh-extra.com/html/extron-electronics/dtp2-r-212-series/dtp2-r-212-series_user-manual_2456698016.webp)
DTP2 R 212 Series • Installation
8
Power inlet
on page 7) — Plug the provided external 12 VDC power
supply into this 2‑pole, 3.5 mm captive screw inlet and into an DC power outlet (see
NOTE:
The DTP2 R 212 SA model is supplied with, and requires, a higher‑wattage
power supply (4.2 A, 50 Watts). The non‑SA model can use a standard 2.0 A,
24 Watt supply.
HDMI input
— Connect a HDMI video source to this female type A HDMI connector.
This port can also accept DVI video with appropriate adapter.
NOTE:
LockIt cable lacing brackets are provided to secure the HDMI cables to the
rear panel ports and reduce stress on the connectors, preventing signal loss due
to loose cable connections (see
OVER DTP2 control
— Connect a serial RS‑232 signal, a modulated IR signal,
or both into this 3.5 mm, 5‑pole captive screw port for bidirectional RS‑232 and IR
communication (see
Over DTP2 RS-232 and IR Control
on page 16 to wire the
connector).
DTP2 IN RJ-45 port
— Plug one end of a DTP2 cable to this RJ‑45 female port.
Plug the opposite end of this cable into the DTP port on a compatible transmitter (see
TP Connector and Cable Recommendations
on page 13 to wire the RJ‑45
•
Signal LED
— Lights green when the unit is sensing a TMDS clock signal on the
DTP2 input.
•
Link LED
— Lights amber to indicate a valid link is established between the units.
ATTENTION:
•
Do not connect this device to a telecommunications or computer data network.
•
Ne connectez pas cet appareil à un réseau de télécommunications ou de
données informatiques.
Send Power toggle switch
(see
on page 7) — The
Send Power
switch
enables or disables the sending of power from the receiver to a DTP2 transmitter.
Set the toggle switch to the
UP
(Send Power)
position on the powered DTP2 unit to
enable sending remote power to the other device. Set the toggle switch to the
DOWN
(OFF)
position on the DTP2 unit receiving power.
NOTES:
Guidelines for setting the
Send Power
switch:
•
If you are using the DTP2 R 212
SA
(amplified audio) receiver, the power output
of the DTP2 transmitter
is not
enough to power the receiver. You can send
power from the receiver to the transmitter,
but not
from the transmitter to the
receiver (see
•
If you are using the DTP2 R 212 receiver (not the
SA
model), the power output
of the DTP2 transmitter
is
enough to power the receiver. You can send power
either way, if desired (see
Summary of Contents for DTP2 R 212 Series
Page 2: ...Safety Instructions...
Page 6: ......