Extron electronics DTP CrossPoint 108 4K, Setup Manual

Page: 14 / 44

6 DTP CrossPoint 4K Series • Installation
D HDMI outputs
(see
figure 2
on page 4 and
figure 3
on page 5) — Plug HDMI video displays (or DVI with
appropriate adapters) into these ports. See
HDMI
connectors to secure the connectors to the enclosure with a
LockIt HDMI Cable Lacing Bracket.
The following table identifies the HDMI outputs by matrix size.
Matrix Outputs Matrix Outputs
10x8 1, 2, 3, 4, 5A, 6A 8x6 1, 2, 3A, 4A
8x4 1, 2, 3A, 4A 8x2 1A, 2A
NOTE: The signal output on the n A HDMI output (such as
5A) is duplicated on TP output
n
B (such as 5B).
E
TP (XTP/HDBT/DTP) switches (see figure 2 and figure 3 ) —
XTP
DTP HDBT
ATTENTION:
• Position this switch BEFORE connecting the
appropriate device to the TP connector. Failure
to comply can damage the endpoint.
• Positionnez le sélecteur AVANT de connecter
l’appareil approprié au connecteur TP. Ne
pas respecter cette procédure pourrait
endommager le point de connexion.
The following table identifies the outputs with TP switches by
matrix size.
Matrix Outputs Matrix Outputs
10x8 5B, 6B, 7, 8 8x6 3B, 4B, 5, 6
8x4 3B, 4B 8x2 1B, 2B
XTP position
— Select if the receiving device is an Extron
XTP matrix switcher. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
HDBT position — Select if the receiving device is a
HDBaseT-enabled device. The TP output consists of HDMI with
embedded audio plus RS-232 and IR.
DTP position — Select if the receiving device is an Extron DTP
device. The TP output consists of HDMI with embedded audio,
analog audio, RS-232 and IR, and remote power.
F TP outputs
(see
figure 2
and
figure 3
) — Plug
SIG LINK
OUT
compatible Extron DTP receivers, XTP matrix
switchers, or HDBaseT-enabled devices into these
RJ-45 ports using TP cables. See
TP connectors on
page 12 to wire the connector.
NOTE: The signal output on the n B TP output (such as 5B)
is duplicated on HDMI output n A (such as 5A).