14
DTP CrossPoint 4K Series • Installation
For the DTP ports only
—
Extron recommends the following practices to achieve full
transmission distances up to 330 feet (100 m) and reduce
transmission errors.
Use the following Extron XTP DTP 24 SF/UTP cables and
connectors for the best performance:
XTP DTP 24/1000
Non-Plenum 1000' (305 m) spool
22-236-03
XTP DTP 24P/1000
Plenum 1000' (305 m) spool
22-235-03
XTP DTP 24 Plug
Package of 10
101-005-02
ATTENTION:
•
Do not connect these boards to a computer data or
telecommunications network.
•
Ne connectez pas ces port à des données informatiques ou
à un réseau de télécommunications.
•
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV
UTP cable or STP201 cable to link the matrix switcher to
Extron DTP products, XTP matrix switchers, or
HDBaseT-enabled devices.
•
N'utilisez pas le câble AV Skew-Free UTP version
améliorée UTP23SF-4 ou le câble STP201 pour relier la
grille de commutation à des produits DTP, à des grilles de
commutation XTP ou à des appareils équipés HDBaseT
Extron.
•
To ensure FCC Class A and CE compliance, STP cables
and STP connectors are required.
•
Afin de s’assurer de la compatibilité entre FCC Classe A
et CE, les câbles STP et les connecteurs STP sont
nécessaires.
NOTE:
When using cable in bundles or conduits, consider the
following:
•
Do not exceed 40% fill capacity in conduits.
•
Do not comb the cable for the first 20 meters, where cables
are straightened, aligned, and secured in tight bundles.
•
Loosely place cables and limit the use of tie wraps or hook
and loop fasteners.
•
Separate twisted pair cables from AC power cables.
Local and Mic/Line audio connectors
Figure 15 shows how to wire each audio type. Use the supplied
tie-wrap to strap the cable to the extended tail of the connector.
Unbalanced Stereo Output
Balanced Stereo Output
Unbalanced Stereo Input
Balanced Stereo Input
Do not tin the wires!
Tip
No Ground Here
No Ground Here
Tip
LR
Sleeves
Tip
Ring
Tip
Ring
LR
Sleeves
Tip
Ring
Tip
Ring
LR
Sleeves
Tip
Sleeve
Sleeve
Tip
LR
Tip (+)
Jumper
Gnd (Sleeve, )
Tip (+)
Ring (–)
Gnd (Sleeve, )
Unbalanced Mono (Mic) Input
Balanced Mono (Mic) Input
Figure 15.
Audio Input and Output Connector Wiring
ATTENTION:
•
For unbalanced audio, connect the sleeves to the ground
contact.
DO NOT
connect the sleeves to the negative (-)
contacts.
•
Pour l’audio asymétrique, connectez les manchons au
contact au sol.
Ne PAS
connecter les manchons aux
contacts négatifs (–).
NOTES:
•
The length of exposed wires is important. The ideal length is
3/16 inch (5 mm).
•
If the stripped section of wire is longer than 3/16 inch, the
exposed wires may touch, causing a short circuit.
•
If the stripped section of wire is shorter than 3/16 inch,
wires can be easily pulled out even if tightly fastened.
•
Do not tin the power supply leads. Tinned wires are not as
secure in the connector and could be pulled out.
15
