12
DTP CrossPoint 4K Series • Installation
3.
Place the LockIt Lacing Bracket on the screw and against the
HDMI connector (see
3
tighten the screw to secure the bracket.
ATTENTION:
•
Do not overtighten the HDMI connector mounting screw.
The shield it fastens to is very thin and can easily be
stripped.
•
Ne serrez pas trop la vis de montage du connecteur
HDMI. Le blindage auquel elle est attachée est très fin et
peut facilement être dénudé
4.
Loosely place the included tie wrap around the HDMI
connector and the LockIt Lacing Bracket (
5.
While holding the connector securely against the lacing
bracket, use pliers or a similar tool to tighten the tie wrap (
and then remove any excess length.
TP connectors
All RJ-45 ports, whether DTP ports, the Expansion port, and the
LAN (Ethernet) ports on the switcher or IPCP control processor use
twisted pair cables (see figure 14).
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
A cable that is wired the same at both ends is
called a "straight-through" cable, because
no pin/pair assignments are swapped.
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
Crossover Cable
Straight-through Cable
Pin
1
2
3
4
5
6
7
8
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
T568A
T568B
End 1
End 2
End 1
End 2
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Pin
1
2
3
4
5
6
7
8
Wire color
White-orange
White-green
Blue
White-blue
White-brown
Brown
Wire color
T568B
T568B
White-orange
Orange
Orange
White-green
Blue
White-blue
Green
Green
White-brown
Brown
Figure 14.
RJ-45 Connector and Pinout Tables
•
Patch (straight) cable
—
•
DTP input and output ports
— Shielded twisted pair
(STP) (preferred) or unshielded TP for connection to
Extron DTP transmitters and receivers, XTP matrix
switchers, or HDBaseT-enabled devices.
•
Expansion port
— STP for connection between the
matrix switcher and a DMP 128. A shielded 1-foot cable is
included with the DMP 128.
•
AV LAN and LAN ports
— Unshielded twisted pair (UTP)
or STP for connection of the LAN port to an Ethernet LAN.
14
