13
DTP CrossPoint 4K Series • Installation
•
Crossover cable
(see
•
AV LAN and LAN ports
— UTP or STP for direct
connection between the switcher and a connected
computer.
NOTES:
•
Do not use standard telephone cables. Telephone cables do
not support Ethernet or Fast Ethernet.
•
Do not stretch or bend cables. Transmission errors can
occur.
AV LAN and LAN ports
The AV LAN and LAN ports require Category (CAT) 3, CAT 5e,
or CAT 6a unshielded twisted pair (UTP) or shielded twisted pair
(STP) cables, crossover or patch cables.
The cable used depends on your network speed. The switcher LAN
port supports both 10 Mbps (10Base-T — Ethernet) and 100 Mbps
(100Base-T — Fast Ethernet), half-duplex and full-duplex Ethernet
connections.
•
10Base-T Ethernet requires CAT 3 UTP or STP cable at
minimum.
•
100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at
minimum.
For ports on an IPCP module, see the
IPCP Pro Series User Guide
at
to make all network connections and to
configure and operate the IPCP control processor.
DTP and Expansion ports
The DTP input and output ports are compatible with Extron
XTP DTP 24 SF/UTP cables or shielded twisted pair (F/UTP,
SF/UTP, and S/FTP) cable. The Expansion port requires CAT 5e, 6,
6a, or 7 shielded twisted pair cable.
For the Expansion port only —
ATTENTION:
•
Connect this port to the Expansion port on a compatible
Extron DMP processor. Do
NOT
connect this port to a LAN
or Power over Ethernet port; equipment damage can occur.
•
Connectez ce port au port d’expansion sur un processeur
DMP d’Extron compatible. Ne connectez
PAS
ce port à un
port LAN ou d’alimentation via Ethernet ; le matériel pourrait
être endommagé.
