Command
ASCII Command
(Host to Scaler)
Response
(Scaler to Host)
Additional Description
Advanced Configuration (continued)
Unsolicited HDCP Statuses
Enable unsolicited HDCP
responses
E
H
1
NTFY
}
Ntfy
H
1
]
Enable unsolicited HDCP status
responses from the DSC.
Disable unsolicited
responses
E
H
0
NTFY
}
Ntfy
H
0
]
Disable unsolicited responses
from the DSC (default).
View unsolicited
responses state
E
H
NTFY
}
X4(
]
In verbose modes 2 and 3:
Ntfy
H
X4(
]
View state (On-Off) of unsolicited
HDCP status responses.
On-Screen Menu Configuration (Front Panel Control Button Emulation)
NOTES:
•
An
E13
error code is returned if a navigation button command
other
than
R
MENU
(right arrow button) is sent while
the OSD menu system is Off.
•
The right arrow command can be used to initiate an Auto-Image, therefore, it does not return an error code.
•
An
E14
error code is returned if a menu emulation command is sent while the unit is in front panel lock mode.
•
The unit exits power save mode if a menu emulation command is sent while the DSC is in power save mode.
Toggle menu on and off
E
M
MENU
}
Menu
M
]
Emulate the front panel
Menu
button: Toggle the OSD menu
on and off.
Enter menu system
E
A
MENU
}
Menu
A
]
Discretely enter the OSD menu
system.
Exit menu system
E
X
MENU
}
Menu
X
]
Discretely exit the OSD menu
system.
Enter (select)
E
E
MENU
}
Menu
E
]
Emulate the
Enter
button
(select a submenu or item)
Up Arrow
E
U
MENU
}
Menu
U
]
Emulate the
button.
Down Arrow
E
D
MENU
}
Menu
D
]
Emulate the
button.
Left Arrow
E
L
MENU
}
Menu
L
]
Emulate the
t
button.
Right Arrow
E
R
MENU
}
Menu
R
]
Emulate the
button.
View menu status
E
MENU
}
X3)
]
In verbose modes 2 and 3:
Menu
X3)
]
View the OSD menu On-Off
status.
Resets
System reset
E
ZXXX
}
Zpx
]
Reset all device settings to
factory defaults
Absolute system reset
E
ZQQQ
}
Zpq
]
Set all device settings plus
DHCP and the IP address to
factory defaults. DHCP = Off, IP
address =
192.168.254.254
.
Absolute system reset,
retain IP settings
(Recommended for after
a firmware update.)
E
ZY
}
Zpy
]
Same as absolute system reset
except that IP address, subnet
mask, gateway address, DHCP,
and port mapping are not reset.
NOTE:
X2(
= Front panel lock mode (executive mode):
0
= Unlock front panel (default),
1
= Lock front panel
X3)
= OSD menu status:
0
= Off (default),
1
= On (displayed).
X4(
= Unsolicited signal or HDCP status response:
0
= Enabled,
1
= Disabled.
DSC HD-HD 4K Plus A Series • Remote Configuration and Control
64