Extreme Networks ExtremeWare XOS 10.1, Manual

Page: 227 / 256

ExtremeWare XOS 10.1 Concepts Guide 227
A
Software Upgrade and Boot Options
This appendix describes the following topics:
• Downloading a New Image on page 227
• Saving Configuration Changes on page 229
•
Using TFTP to Upload the Configuration on page 231
• Using TFTP to Download the Configuration on page 232
• Accessing the Bootloader on page 232
Downloading a New Image
The image file contains the executable code that runs on the switch. It comes preinstalled from the
factory. As new versions of the image are released, you should upgrade the software running on your
system.
The image is upgraded by using a download procedure from either a Trivial File Transfer Protocol
(TFTP) server on the network or from a PC connected to the serial port using the XMODEM protocol.
Downloading a new image involves the following steps:
• Loading the new image onto a TFTP server on your network (if you will be using TFTP).
• Loading the new image onto a PC (if you will be using XMODEM).
• Selecting the partition to use when downloading an image. For more information, see “Selecting a
Primary or a Secondary Image” on page 228.
• Downloading the new image to the switch using the following command:
download image [<hostname> | <ipaddress>] <filename> {[{vr} <vrid>]}
Where the following is true:
hostname
—Is the hostname of the TFTP server. (You must enable DNS to use this option.)
ipaddress
—Is the IP address of the TFTP server.
filename
—Is the filename of the new image.
vrid
—Is the name of the virtual router.