Extreme Networks EN-SLX-9030-48S-4C, Hardware Installation Manual

Page: 57 / 114

NOTE
Power is supplied to the device as soon as the first power supply is
connected.
4. After the device has booted, verify that the power and status LEDs are green. The power supply LEDs display amber until
power-on self-test (POST) is complete, and then change to green. The switch usually requires several minutes to boot and
complete POST.
NOTE
To turn the system off, simply unplug the power
cables.
For more information about how to interpret LEDs, refer to Monitoring the Device on page 77 under LED Port Behavior section.
Establishing a serial connection
To establish a serial connection to the console port on the device, complete the following steps.
1. Verify that the device is powered on by verifying that all power LED indicators on the management, interface, power supply, and
fan modules display a steady green light.
2. Connect the RJ-45 serial cable provided with the device to the management Ethernet port of the device.
FIGURE 28 Port-side view of the SLX 9030 Switch
1. Console/management port
2. USB port
3. 1Gb/10Gb SFP+ ports (SLX 9030) or 1GB/10GBASE-T
ports (SLX 9030-T)
4. 10Gb/40Gb QSFP+ port
5. 10Gb/25Gb/40Gb/100Gb capable QSFP28 ports
NOTE
The console/management port is intended primarily for the initial setting of the IP address.
3. Access the device using a terminal emulator application (such as HyperTerminal in a Windows environment or Tip in a UNIX
environment).
4. Disable any serial communication programs running on the workstation (such as synchronization programs).
Establishing a serial connection
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD 57