Extreme Networks EN-SLX-9030-48S-4C, Hardware Installation Manual

Page: 17 / 114

FEC Mode - Disabled
:
•
device# show ip interface brief
Interface IP-Address Vrf Status Protocol
================== ========== ================== ==================== ========
Ethernet 0/1 unassigned default-vrf administratively down down
Ethernet 0/2 unassigned default-vrf administratively down down
:
Ethernet 0/51:1 unassigned default-vrf administratively down down
Ethernet 0/51:2 unassigned default-vrf administratively down down
Ethernet 0/51:3 unassigned default-vrf administratively down down
Ethernet 0/51:4 unassigned default-vrf administratively down down
Ethernet 0/52 unassigned default-vrf administratively down down
Enabling FEC
Port FEC mode is supported only on 100G ports. FEC is disabled on 1/10/40-G Speeds (including breakout ports). Link peers must
be in the same FEC mode (RS-FEC). The FEC configuration is applied once speed change is initiated.
device(conf-if-eth-0/52)# fec mode
Possible completions:
RS-FEC Set FEC mode to RS-FEC in manual mode
disabled Set FEC disabled
device(conf-if-eth-0/52)# fec mode disabled
Verifying media
Verifying media on an SLX 9030-48S:
SLX# show media
Interface Ethernet 0/1
Identifier 3 SFP
Connector 7 LC
Transceiver 0000000000000010 10_GB/s
Name sw
Encoding 6
Baud Rate 103 (units 100 megabaud)
Length 9u 0 (units km)
Length 9u 0 (units 100 meters)
Length 50u 8 (units 10 meters)
Length 62.5u 3 (units 10 meters)
Length Cu 0 (units 1 meter)
Vendor Name Extreme
Vendor OUI 00:05:1e
Vendor PN 57-0000075-01 (10GE SR SFP+)
Vendor Rev A
Wavelength 850 (units nm)
Options 001a
BR Max 0
BR Min 0
Serial No AAA210503534952
Date Code 101219
Optical Monitor Yes
Temperature 24 Centigrade
Voltage 3317.2 (mVolts)
Current 0.002 (mAmps)
TX Power 0.1 (uWatts) / -40.000 (dBm)
RX Power 0.1 (uWatts) / -40.000 (dBm)
Management commands
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD 17