Exabyte EZ17A, Installation And Operation Manual, Page: 89 / 168

Autoloader Operation
Installation and Operation 73
To reset the autoloader, use one of the following methods:
§
Press
[RESET]
on the operator panel, then press
[ENTER]
at the
confirmation screen (or press
[ESCAPE]
to cancel).
§
Perform a power-on reset by powering the autoloader off,
waiting 10 seconds, then powering it back on.
When the power-on self-test is complete, the Status screen
appears on the LCD.
Note:
If the autoloader is performing a cartridge move operation
when it is reset, it attempts to complete the move
operation after it performs the power-on self-test.
CAUTION
Wait at least 10 seconds between powering the
autoloader off and turning it back on again to
allow the drive sufficient time to complete its
reset operation.