Exabyte EZ17A, Installation And Operation Manual, Page: 158 / 168

Appendix C
142 Exabyte EZ17M and EZ17A
197
Tape in drive can’t move.
Command cannot be executed
because there is a cartridge in the
tape drive. Remove the cartridge from the tape drive
and reissue the command.
198
CHM full before move. There
w as a cartridge in the robot
before a move operation,
initialize element status, or
diagnostic test.
§
Remove the magazine and look for
anything that might be obstructing the
robot.
§
Make sure the autoloader is not being
used by any host, then reset the
autoloader from the operator panel. If
necessary, pow er the autoloader off,
w ait 10 seconds, then power it on
again to reset the tape drive.
CAUTION: Wait at least 10 seconds
between pow ering the autoloader off and
turning it back on again to allow the tape
drive sufficient time to complete its reset
operation.
§
If the error persists, contact your
service provider. You may be asked to
supply a diagnostic listing, and you
may need new firmw are.
199
Remove tape in drive. The
cartridge must be removed
before the autoloader can begin
its POST. Remove the cartridge from the tape drive.
210
Remove all tapes for calib. All
cartridges must be removed so
the autoloader can begin
calibration.
§
Remove the magazine (it is unlocked).
§
Remove cartridges from all the
magazine slots, the tape drive, and the
picker.
§
Replace the magazine. The autoloader
w ill automatically calibrate.
Error
no.
Description Corrective action