Exabyte EZ17A, Installation And Operation Manual, Page: 157 / 168

Error Codes
Installation and Operation 141
97
Drive not installed. There is not
a tape drive installed.
§
Make sure the autoloader is not being
used by any host, then reset the
autoloader from the operator panel. If
necessary, pow er the autoloader off,
w ait 10 seconds, then power it on
again to reset the tape drive.
CAUTION: Wait at least 10 seconds
between pow ering the autoloader off and
turning it back on again to allow the tape
drive sufficient time to complete its reset
operation.
§
If the error persists, contact your
service provider. The cable
connection between the tape drive
and the autoloader may be loose.
130 SCSI chip error; SCSI
unexpected int; SCSI int stuck
error. There is a SCSI chip failure.
§
Make sure the autoloader is not being
used by any host, then press
[RESET]
on
the operator panel.
§
If the error persists, contact your
service provider or Exabyte Technical
Support. You may be asked to supply
a diagnostic listing; you may need new
firmw are or a new controller card.
131
132
133
134
135
136
137
194
All slots are full. All data
cartridge magazine slots contain
a cartridge. This error only appears w hen you are
performing a demo. Remove at least one
cartridge from the magazine.
195
All slots are empty. All data
cartridge magazine slots are
empty. This error only appears w hen you are
performing a demo. Insert at least one
data cartridge into the magazine.
Error
no.
Description Corrective action