13
6.0 In s ta llation an d in itial o p eration
Authorized personnel
The installation and initial operation may only be conducted
by qualified personnel.
WARNING
Risk of injury and material damage due to incorrect installation of
the accessories
Therefore:
• Optional devices may only be installed in accordance with their
respective instructions.
6.1 Installation location
Install in a location where the actuator is not exposed to
strong UV radiation or corrosive or explosive air media.
6.2 Inspections prior to
initial operation
Performed by professional electrician.
Prior to the initial operation, a professional electrician must
perform and document the following tests and readings:
• Check visual condition
• Function check of operating features and safety features
NOTE
See additional information concerning inspections and readings
(⮑ 8 Maintenance, page 21).
6.3 Installation
Installation is to be performed by trained personnel.
WARNING
Risk of injury and material damage due to loosening or
removal of the screws on the device
Removal or loosening of the screws on the linear unit may lead to
injuries and material damage during the operation.
Therefore:
• Never loosen or remove screws on the linear unit.
6.0 Installation and initial operation
The CASM-100 Linear actuator (see image below) is at-
tached to two elements via the push tube and the mounting
accessories.
1. Assemble the motor onto the linear unit if the product is
not premounted (⮑ 7.5 Installation instruction CASM-
100, page 16).
2. Screw the rod clevis or rod end (2) on the push tube and
tighten up the two screws.
2
3. Bolt the mounting accessories to the actuator if not pre-
mounted (⮑ 4.3.1 CASM-100 accessories overview,
page 9).
4. Secure elements of the application in which the linear
actuator will be installed.
5. Connect the rod end (2) and the mounting accessories
(1) and the elements of the application with the fastening
bolts (see image below).
1
2
