Ewellix CASM-100, Installation, Operation And Maintenance Manual

Page: 17 / 30

17
7.0 O p eration
NOTE
For the following steps, check the required screw size and the
tightening torques using the values indicated in table 1 and 2.
7.5.4 Synchronous Servo Motors
Inline mounting
S
M
C
G S
MF
G S
GB
C
LU
G
• Attach the coupling (C1) on the linear unit (LU) using screw
(S4) as described in 7.5.3.
• Fit the inline gearbox (GB) on the linear unit (LU) by insert-
ing the gasket (G1) between the two components and
tightening the housing using four screws (S1).
• First put the gasket (G2) on the inline gearbox (GB) then at-
tach the motor flange (MF) to the inline gearbox (GB) and
tighten the screws (S2).
• Attach the coupling (C2) to the motor (M) using screw (S4).
• Put the sealing (G3) into the groove in the motor flange
(MF) and tighten the screws (S3) to secure the motor (M) to
the motor flange (MF).
S1 S4
S2 S3
Table 1
Screw size/tightening torques (parallell)
Siemens Motor type S1 (Gearbox) S2 (Motor adapter) S4 (Coupling) S3 (Motor)
Screw Torque M
A
Screw Torque M
A
Screw Torque M
A
Screw Torque M
A
1FK704X M12x40 75 Nm M8x30 20 Nm M6x20 15 Nm M6x30 10 Nm
1FK706X M12x40 75 Nm M8x30 20 Nm M6x20 15 Nm M8x30 20 Nm
1FK708X
M12x40 75 Nm M8x30 20 Nm M6x20 15 Nm M10x30 40 Nm
1FK710X
M12x40 75 Nm M8x30 20 Nm M6x20 15 Nm M12x40 75 Nm