DEPOLOX® Pool Compact
6. Operation
59
EN
Unlock pattern:
Menu for entry/definition of a Level 3
unlock pattern. The entry must be
repeated as confirmation.
Password:
Menu for entry/definition of a Level 3
password. The entry must be repeated
as confirmation.
Level 2:
If access control is enabled, Level 2 can
be enabled or disabled. Level 2 allows
access to setting parameters such as
limit values, setpoint, date, time and
calibration. If Level 2 is enabled, an
unlocking pattern and/or a password
must be defined.
Unlock pattern:
Menu for entry of a Level 2 unlock pat-
tern. The entry must be repeated as
confirmation.
Password:
Menu for entry of a Level 2 password.
The entry must be repeated as confir-
mation.
Level 1:
If access control is enabled, Level 1 can
be enabled or disabled. Level 1 allows
access to calibration. If Level 2 is not
enabled, access to limit values and set-
points is also possible on Level 1. If Level
1 is enabled, an unlocking pattern and/
or a password must be defined.
Unlock pattern:
Menu for entry/definition of a Level 1
unlock pattern. The entry must be
repeated as confirmation.
Password:
Menu for entry/definition of a Level 1
password. The entry must be repeated
as confirmation.
Connection - Network
IP Adress:
Enter a fixed IP address (contact net-
work administrator)
Subnet mask:
Enter the subnet mask (contact network
administrator)
Gateway:
Gateway settings
DHCP:
On/Off
In the setting “DHCP = On,” the network
configuration is automatically defined
by the DHCP server and cannot be confi-
gured manually. The network settings
are displayed.
In the setting “DHCP = Off,” the network
settings must be configured manually.
Status:
Http Modbus
Connection - RS485 interface
Function:
Select the RS485 interface function.
The RS485 interface supports the bus
communication with the Process Moni-
toring System or other superordinate
systems that support the RS485-WT pro-
tocol. Various operating modes are
integrated to be compatible with old
devices.
RS485-WT protocol (new address refe-
rence list).
RS485 PCS plus (1) (address reference
list
is compatible with the PCS plus 1-
address operation) RS485 PCS (3)
(address reference list is compatible
with the PCS 3-address operation)
Bus adress:
Bus address setting at the RS485 Inter-
face (RS485 WT) 00 to 31.
Bus adress 1/2/3:
Bus address setting at the RS485 Inter-
face PCS (3) operating mode for Cl2 (1),
pH (2) and ORP (3) 00 to 31
Status:
RxD TxD
Active Error
Backup and Reset
Reset to factory setting:
Under Factory setting, the device can be
reset to the factory settings. When the fac-
tory settings have been restored, the reset
settings have to be entered again. You can
select which settings are to be reset.
