10
Prepare for Your New Spa
PLEASE CHECK YOUR LOCAL BUILDING CODES AND ONLY USE A CERTIFIED ELECTRICIAN TO
INSTALL ANY ELECTRICAL COMPONENTS TO YOUR SPA.
Step
4
.
Turn Dip
switch #10 off (down).
All other
D
ip
switches should remain
the
same
unless mode change is to be
enabled.
Mode change VS300FL4
Mode change VS501Z
Step
7
.
After all other steps have been
completed, follow all instructions
for a 240 volt install.
Step
5
.
(optional)
Enable mode change.
A plug and play spa comes from the
factory locked in standard mode so
that the mode cannot be changed. To
enable mode change, a dip switch
must be turned to the off (down)
position. Depending on the model of
spa pack within the spa, the specific
dip switch that would need to be
changed will vary. If you have a
VS501z spa pack, you will turn dip
switch 2 off (down). If you have a
VS300 spa pack you will turn dip
switch 7 off (down).
Step
6
.
Remove 120 volt GFCI cord
.
A plug and play spa comes from the
factory
with 120 volt GFCI cord
installed. To hook the spa up to 240
volts, the 120 volt GFCI cord must
first be removed.
