Evinrude E-Tec 40 HP, Service Manual

Page: 149 / 426

147
FUEL SYSTEM
FUEL COMPONENT SERVICING
7
tor filter. Install new crush ring and O-rings. Lubri-
cate O-rings with
STP
†
Oil Treatment
.
Install injector into mount housing. Press on injec-
tor face until injector seats in mount housing.
Installation
All injectors must be installed in the
correct cylinder by serial number. Improper
injector installation can result in powerhead
failure.
Installation of a replacement injector requires that
coefficient data for the new injector is uploaded to
the
EMM
.
Coefficient data for some replacement injectors is
supplied on a compu ter d isk shipp ed with th e
injector. If a disk is not included with the injector,
coefficient dat a ca n be downloade d from th e
Evinrude/Johnson
dealer website. Ref er to th e
instructions provided with the injector kit.
Upload Coefficient Files to EMM
IMPORTANT:
If using Diagnostic Power Supply
Tool, P/N 587005, to supply po wer to th e
EMM,
use Accessory Power Cable Kit, P/N 5008092, to
connect an external 12 volt battery to the Power
Supply Tool.
If the internal batteries of the Power Supply T ool
have a low volt age condition the
EMM
could turn
OFF during the coefficient upload, resulting in a
failed update.
Use t he
Evinrude Diagnostics
so ftware
Settings
screen to upload the coefficient file to the
EMM
.
Select the
Injectors
tab.
Select the cylinder tab for injector being replaced.
Select the
Replace Injector
button.
1. Adaptor
002196
1. Crush ring
2. O-rings
002317
002318
1
2
1
1. “Replace Injector” button
008568A
NOTICE
1