Evinrude E-TEC 200, Service Manual

Page: 39 / 416

37
ROUTINE SERVICE
LUBRICATION
2
•
Inner casings of both the throttle and shift
cables.
Shift the remote control to the NEUTRAL/IDLE
position.
Install control cables.
Check proper throttle and shift function.
Propeller Shaft
Debris from the water can become lodged around
propeller shaft. Frequent inspection can minimize
potential gearcase damage.
Remove propeller. Refer to Propeller Hardware
Installation on p. 285.
Inspect bushing and blade surfaces. Replace
damaged or worn propellers.
Clean propeller shaft. Inspect propeller shaft
seals. Replace damaged or worn seals.
Apply Triple-Guard grease to entire length of pro-
peller shaft prior to installing propeller.
Reinstall propeller hardware and propeller.
Gearcase Lubricant
Draining
IMPORTANT:
Always check the fill level of the
gearcase lubricant at the upper plug before
removing the lower, drain/fill plug. A tie strap can
be used to check lubricant level.
If lubricant level is low, refer to GEARCASE LEAK
TEST on p. 286.
Remove the lubricant level plug, then the lubricant
drain/fill plug, and drain the lube from the gear-
case into a container.
1. Attachment pins, throttle and shift cables
2. Shift shaft grease fitting
3. Inner casings, throttle and shift cables
DRC6500R
WARNING
When servicing the propeller, always shift
the outboard to NEUTRAL, turn the key
switch OFF, and disconnect the battery
cables at the battery.
3
2
1
WARNING
Gearcase lubricant may be under pressure
and/or hot. If plug is removed from a
recently operated outboard, take precau-
tions to avoid injury.
1. Tie strap 000072
1. Lubricant level plug
2. Lubricant drain/fill plug
39514
1
1
2